Document No. 3 — Reverse Engineering and Reconstruction of Design Logic

Principles of This Document

Principle 1 — Reverse Engineering Goes Beyond Measurement

The objective is to reconstruct the engineering decisions that led to the component’s existing shape and performance.

Principle 2 — Understanding the Component Before Measurement

The component’s function, place of use, history, condition, repairs, and available documentation must be understood before carrying out precise measurements.

Principle 3 — Distinguishing Reconstruction from Redesign

When design information is unavailable, the boundary between reconstructing the existing design and redesigning the component must be clearly defined.

Principle 4 — Reconstructing the Design Philosophy

It must be determined whether the component was designed to prevent failure, allow controlled failure, provide warning before failure, or achieve a specified service life.

Principle 5 — Material Characteristics Are Determined by Multiple Factors

Chemical composition alone does not determine material behavior. The process, heat treatment, coating, and service conditions also have an influence.

Principle 6 — Reconstruction Before Improvement

The existing logic must first be reconstructed. Only then, if sufficient grounds exist, should an improved solution be designed.

Principle 7 — Validating the Prototype Under Actual Conditions

The prototype must be tested under actual operating conditions, and the test results must be used in developing the next prototype.

Principle 8 — Project Evidence Takes Precedence Over External Clues

Reference samples, manufacturers, and external sources should be treated as leads, and their claims must be validated against project evidence.

Principle 9 — Every Test Must Address an Engineering Question

The selection of tools and tests must be purposeful and appropriate to the engineering question being addressed.

Principle 10 — Documentation Is Essential to Converting Experience into Organizational Knowledge

Experience must be recorded in the engineer’s logbook, project file, and a retrievable archive.